HVH Super Sucker 604 Carburetor 4-Hole Spacer, 5/8 Inch

$138.99

Spacer will increase air speed from the base of the carburetor to the top of the intake valve and will end up pulling more fuel from the carburetor
Super Sucker will require a change in the size jet currently being used. E.T. is reduced as much as 1/10 of a second and lap times reduced as much as 2/10 of a second
Designed to improve throttle response, drivability, top end horsepower and torque
Specifically designed for the 604 crate engine and gives more low end and mid range torque without reducing top end torque
Made of anodized aluminum and measures 5/8″ thick

Compare

Description

Overall Thickness: .625″

Gasket(s) Included: No

Hardware Included: No

Material Type: Aluminum

Finish: Anodized

Sold in Quantity: Each

Carburetor Spacer Style: 4-Hole

Carburetor Flange Type: 4-Barrel Square Bore

Info

Designed by Joe Petelle at HVH over 15 years ago for Winston Cup engines, this spacer will increase air speed from the base of the carburetor to the top of the intake valve, pulling more fuel from the carburetor, the Super Sucker will require a change in the size jet currently being used. E.T. is reduced as much as 1/10 of a second and lap times reduced as much as 2/10 of a second.

Improvements in the throttle response, driveability, top end horsepower and torque are commonplace when using a Super Sucker.

This 5/8″ aluminum spacer is specifically designed for the 604 crate engine and gives more low end and mid range torque without reducing top end torque.